TAYLAND Nissan Kicks e-POWER · Electrical, electronics and network diagnostic dossier

Correct technical identity

Period

2020-

Platform / generation

P15

Powertrain / energy / driveline

B-SUV seri hybrid • e-POWER; tek oran

Research focus

verify platform/generation, powertrain/energy/driveline and market-specific application identity against manufacturer/source records before applying parts, service procedures or chronic-fault claims.

Step-by-step checks

1. Record battery/12 V rest, crank and loaded voltage together with alternator or DC-DC behaviour.
2. Measure loaded voltage drop at ECU powers and grounds, not only open-circuit continuity.
3. Scan all modules; compare timestamps and shared U-code clusters rather than one module DTC.
4. On CAN, inspect resistance/voltage and when needed dominant-recessive waveform, reflections and noise with a scope.
5. Compare sensor signal with ECU live data and, where possible, a physical reference measurement.
6. For HV isolation/interlock faults, do not disconnect or measure without the required safety procedure.

How to verify the result

Do not make a parts decision from one DTC, sensor value or symptom. Reproduce the fault under the same temperature/load conditions and verify commanded-versus-actual data, electrical measurement and physical result together. Exact OEM limits should only be used when matched to the correct variant service source.

Main variant dossier → · DTC Academy → · Service guide →